A REVIEW STUDY ON APPLICATION AND STRENGTH OF CONCRETE WITH ETP SLUDGE AND LATHE WASTE
Suhaib Firdous, Er. Naveen Saharan
Abstract
Today the construction industry is in need of finding cost effective materials for increasing the strength of concrete structures. It is inevitable to think about sustainable development by reducing the wastes generated or reusing it. Due to rapid growth of population, rapidly increasing in industries which directly increases waste without any management. In this world where some countries are developed and some are developing, the unbelievable demand of steel is on its peak, but it leads toward a dumping ground of industrial waste. For reduction of this dumping of scrap and save the earth from this hazardous problem utilization of steel scrap in concrete is the key step for save the environment and achieving sustainability that will enable the earth to continue to support human life. This paper presents a review study to utilization of waste (CNC lathe waste and ETP Sludge) by partial replacement (5% by weight of natural coarse aggregate) with coarse aggregate.
References
1. Ashish Kumar Parashar et al, “Utility of Wastage Material as Steel Fibre in Concrete Mix M-20”, International Journal of Advancements in Research & Technology, Volume 3, Issue1, August-2012 1 ISSN : 0976-4860 2. Vasudev R., “Experimental Studies of the Application of Turn Steel Scraps as Fibres in Concrete – A Rehabilitative Approach”, International Journal of Engineering and Technology (IJET), ISSN: 0975-4024 Vol 6 No 4 Aug-Sep 2014. 3. Zeeshan Nissar Qureshi, “Strength Characteristics Analysis of Concrete Reinforced With Lathe Machine Scrap”, International Journal of Engineering Research and General Science Volume 4, Issue 4, July-August, 2016, ISSN 2091-2730. 4. Prof. Kumaran M, “Effect of Lathe Waste in Concrete as Reinforcement”, International Journal of Research in Advent Technology (E- ISSN: 2321-9637) Special Issue International Conference on Technological Advancements in Structures and Construction “TASC- 15”, 10-11 June 201. 5. Jais Joy, “ Performance of Steel Scrap in Concrete”, IJSRD - International Journal for Scientific Research & Development| Vol. 2, Issue 12, 2015 | ISSN (online): 2321-0613 6. Saranya C. V, “ Experimental Investigation On Standard Concrete By Using Lathe Industry Waste & Waste Flux Sheet”, International Journal of Science and Engineering Research (IJ0SER), Vol 4 Issue 11 November -2016 7. A.S.bal (1999) “Waste water management for textile industry-an overview” Indian journal of environmental health.41 (40,264-290). 8. D. Fytili, and A. Zabanioto (2006) “Utilization of sewage sludge in EU application of old and new methods” – a review, Renew. Sustain. Energy Rev. 12 (2006) 116–140. 9. M.B. Pescod (1992) “Wastewater Treatment and Use in Agriculture, FAO irrigation and Drainage”. Publication 47, Italy, 1992. 10. L. Tamrabet, H. Bouzerzour, M. Kribaa and M. Makhlouf (2009) “The effect of sewage sludge application on durum wheat (Triticum durum)”. Int. J. Agric. Biol. (2009)741–745. 11. B. Ahmad, K. Bakhsh and S. Hassan (200...